Application Sheet for Spray Drying, Nozzle Specification, Gas Cooling   Personal Information Customer Name   Address   Country   Phone   Email   Fax   1. Spray Drying - The Feed Material Substance being sprayed   % Solids   Specific Gravity (or Density)   Viscostity   Acidic or Alkaline (pH)   The Nozzle Nozzle type presently being used:   Manufacturer   Number Of Nozzles   Rated flow and spray angle   Average wear life   Pipe Size   The Dryer Dryer Manufacturer   Inlet air temp   Cocurrent or countercurrent air   Outlet air temp   Dryer diameter at nozzle position   Maximum pump pressure   Pump Maufacturer   Operating Pressure   The Dry Product % Moisture   Density   Pounds per hour   Solubility   2. Nozzle Specification Information Flow Rate (LPM, Gallons/Min,   M3/Hr, Kg/Hr)   Operating Pressure (Bar.G, PSI.G, Kg/cm2, kPa(kilo Pascals), Head in Metres)   Spray Angle   Liquid being sprayed   Type of spray patterns:   Flat                Solid Cone/ Circular or Square              Hollow Cone              Air Atomising   If different from water the following are required:   Density   Viscosity   Surface Tension   Solids Content   Application or Purpose of Nozzle   Washing Rinsing   Cleaning in Place Gas Scrubbing   Humidification Quenching   Aeration of liquids   3. Gas Cooling Information Inlet gas temperature  oC    oF   Outlet gas temperature  oC    oF   Volume of Gas  SCFM    NM3/hr   Cooling chmaber dimensions: Circular   Rectangular   Diameter        Height   Length        Width          Length

Copyright © 2004 P.M.S Engineering (Intl.) Services. All rights reserved Site Maintained by Ayush Gupta